SolidWorks: How can I dimension to the edge of a circle or arc

slot dimension in drawing   Dan slot สายบุญ

Dimensioning, Continued Slotted holes Dimension slotted holes by width, length, or center points Indicate the end radii but do not dimension them Figure 3

A slot is to be milled centrally on a block with a dimension of 40 ± mm A milling cutter of 200 mm width is located with reference to A slot is really just an elongated hole, so first you'd need to know the hole diameter Then you can either call out the dimension from center-to-center on the

slot game reviews A dimension in a drawing consist of the following items: dimension arrow, Arrow can be outside the arc Page 23 Slot Dimensioning Two acceptable  What could be causing this issue? I'm stumped Sketch on Part Drawing of Part