Game Changer for Prepping Fret Slots Fast and Perfect: Micro End

It shows you if the fret slot will accept the fret wire that you're about to use What you do is put the fret tang up to these two mark lines The lower line is

Game Changer for Prepping Fret Slots Fast and Perfect: Micro End Most fret slotting profiles are a standard ″ width at the tang, our 18″ shank Fret Router bit works well for cutting 023″ fret slots It also can be

It shows you if the fret slot will accept the fret wire that you're about to use What you do is put the fret tang up to these two mark lines The lower line is

4xbet slot A correct fingerboard thickness should be roughly 14″, meaning your cut depth should roughly be 18″ Cutting at a 18″ depth will ensure that

GUITAR FRET SAW WITH SLOT DEPTH GAUGE

fret slot depth It shows you if the fret slot will accept the fret wire that you're about to use What you do is put the fret tang up to these two mark lines The lower line is

The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken