Moving Fastboot to Userspace

website fastboot_ error_ failed to identify current slot If you end up in a situation, where your FP3 cannot get into fastboot on either slot, there is now an unbricking solution available using EDL fastboot get active slot The output contains the slot, state, current run number, current command in errlog Error level loopscn Current loop state during

fastboot_ error_ failed to identify current slot current generation devices Deleting a profile will wipe the corresponding Weaver slot and a factory reset of the device wipes all of the Weaver slots   AB devices don't have a recovery partition OP needs to do 'fastboot boot > and then flash the installation zip   current generation devices Deleting a profile will wipe the corresponding Weaver slot and a factory reset of the device wipes all of the Weaver slots

Share

Share

Link

Turn off sharing Copy link

See all details